top of page
SANKO GOSEI

Development of motor valve gate (1)

Updated: Nov 18, 2022

▶Conventional valve gate defects

The valve gate can freely set the resin injection timing by opening and closing the valve pin.

However, since the valve pin can only be turned on and off by pneumatic or hydraulic pressure, it is not possible to control the delicate discharge rate of injection.

In addition, if the gate is balanced, burrs are likely to occur.

If it is difficult to balance the filling with a family mold, it is necessary to use a single stroke molding method.

If the position of the valve pin can be freely adjusted, wouldn't it be possible to control the flow rate as desired, like a water tap?

Therefore, we developed a valve gate system that can control the valve gate pin at any position.

By controlling the resin flow rate, we aimed to equalize the in-mold pressure during molding.

~関連記事~

50 views0 comments

Recent Posts

See All

Comments

Rated 0 out of 5 stars.
No ratings yet

Add a rating

Concerns about plastics
Did you solve?

You can find the desired content from the
top page content from the top page.

23989485.png

★月間アクセスランキング★

bottom of page