top of page
SANKO GOSEI

Development of motor valve gate (3)

Updated: Nov 18, 2022

Prototype fabrication

Due to the long overall length of the cylinder, it is impossible to place it on the same straight line as the valve pin.

Therefore, the valve pin and cylinder are placed on a parallel line, and the valve pin is controlled to open and close via a cam.

The opening and closing of the valve pin is controlled by a cam.

More detailed control can be achieved by changing the ratio of the cam.

            Motor Valve Gate (Prototype) 

3 STEP operation is possible via a dedicated controller.

(ST=10mm, thrust 300kgf, maximum speed 33mm/sec)


The prototype cleared the target values, but it became necessary to take thermal countermeasures at the same time in consideration of continuous molding.


~関連記事~

40 views0 comments

Recent Posts

See All

Commentaires

Noté 0 étoile sur 5.
Pas encore de note

Ajouter une note

Concerns about plastics
Did you solve?

You can find the desired content from the
top page content from the top page.

23989485.png

★月間アクセスランキング★

bottom of page