top of page
SANKO GOSEI

Gas venting defects in cylindrical shape (2)

Since venting gas from the vertical direction is not sufficient for a product with a cylindrical shape, a structure to vent gas from the inner diameter surface of the cylinder was considered.

As a result, we developed a gas venting insert (SG-WIND) exclusively for cylindrical shapes.

This SG-WIND has two gas venting systems, so it has a high gas exhaust capacity.

Note that a shaft must be inserted to accommodate the shrinkage force of the resin when it is incorporated into the mold.

After incorporating this SG-WIND into the mold, weld lines were no longer noticeable and mass production was possible without molding defects.








0 views0 comments

Recent Posts

See All

Comments

Rated 0 out of 5 stars.
No ratings yet

Add a rating

Concerns about plastics
Did you solve?

You can find the desired content from the
top page content from the top page.

23989485.png

★月間アクセスランキング★

bottom of page