top of page
SANKO GOSEI

Stable gas supply technology for foam molding technology (SG-FORMⅡ) ③.

Updated: Jun 27, 2023


In the past, the amount of gas injected was only estimated based on the pressure difference.

The flow rate is controlled to inject from the beginning to the end of the lightweight

In addition, the timing of gas injection is

We made sure to inject from the beginning to the end of the weigh-in



21 views0 comments

Comments

Rated 0 out of 5 stars.
No ratings yet

Add a rating

Concerns about plastics
Did you solve?

You can find the desired content from the
top page content from the top page.

23989485.png

★月間アクセスランキング★

bottom of page